Always keep the testing sample and pen by hand, you can use them as many times as you want. After you are sure it is good to mark, then mark on the good products for customers. Test it, then use permanent to paint it, and then adjust the parameters if needed. In order not to waste new products, keep 1 product as testing sample. If the rotary is a little shaking when rotates, lower the speed of Min Speed and Max Speed. Or it will shows Go homing when press light or mark.
#Rotate image in electrox scriba driver
The nunber is related to the rotary driver settings, the rotary driver is installed inside the machine. When use a rotary to mark Text or Numbers, it is better to use RotateTextMark which is better than SplitMark2. If the total marking length is 50mm, when you set the split size as 10, it means 50/10=5, it is splited to 5 parts, the rotary will rotate 5 times to finish the marking. If the diameter is around 100mm, usually we set split size around 1-10, set 10 first and try. For example, if the diameter was 100mm, try to change it to 98mm, and then mark again and check.Īfter rotating marking, if you see some split lines and some other repeatedly marking, try to adjust split size first.
#Rotate image in electrox scriba software
Since many laser engravers have issues to get the rotary to work normally, below are some tips for your reference including driver settings, software settings, operating advices etc.Īfter rotating marking, if you see several split lines which looks almost same, first try to adjust the Diameter.
0 kommentar(er)
